Rev. 7/95
- Action -
Is the drum charge roller adjustment factor (SP2-001) at the correct value?
Yes
No
Set SP2-001 to the factory set value.
Adjust the exposure lamp voltage (SP4-001)
Perform ADS initial setting (SP4-201) and forced V
Is the drum charge roller temperature is 0°C or 60°C
No
Yes
Is the drum charge roller thermistor connector connected properly?
Yes
No
Connect the drum charge roller thermistor connector
Replace the drum charge thermistor
Are both the following conditions true? a) Is the auto process contol mode se-
lection SP3-801 set to ON? b) Is initial V
Yes
No.
Clean the optics and adjust the exposure lamp voltage (SP4-001)
Perform ADS initial setting (SP4-201) and forced V
Set SP3-801 to 1
Perform forced V
FT5535/4527/4522
/V
LP
detection (SP3-112)
R
6-6
detection (SP3-105)
L
(SP3-106) not 0?
LG
detection (SP3-105)
L
FSM