Ricoh FT5535 Service Manual page 306

6.4.2 Wire Installation
[A] [E]
[B]
[K]
[P]
[Q]
[J]
- Front -
[A]
599mm (23.58")
1. Put the bead [A] at the end of the wire in the slot in the wire pulleys [B, C],
2. Insert the pin [D] into the bin drive shaft [E] and then push in the wire pulleys.
3. Wind the wire one and a half turns as shown and put the bead [F] in the slot
in the bin support block [G].
4. Put the bin support block stopper [H] on the bin support block.
5. Run the wires over the pulleys [Front wire: I/J/K, Rear wire: L/M/N/O] and put
the bead [P] in the slot in the bin lift shaft [Q].
6. Reassemble the sorter stapler.
NOTE: When installing the bin drive bracket, make sure that the bin lift wires
are wound from the inner side to the outer side of the pulleys as
shown.
FT5535/4527/4522
[D]
[I]
[F]
[G]
[H]
[F]
[F]
877.6 mm (34.55")
10-24
Rear
[E]
[A]
[C]
[G]
[H]
[M] [N]
- Rear -
Front
[D]
[L]
[O]
[Q]
[P]
[P]
FSM