Ricoh FT5535 Service Manual page 83

Rev. 7/95
Mode No.
5-801 Memory All
Clear †
5-802-001 Free Run Mode Performs the free run
to
5-802-002
5-803 Input Check
Mode †
5-804 Output Check
Mode
°5-810 SC Reset †
5-811 Machine Serial No. Input †
For use with features that are available in Japan only
°5-812 Telephone
Number Input †
(A156 copier
only)
°5-816 RDS/CSS Function Setting †
For use in Japan only. Do not change the factory setting.
5-817 Repair Time Transmission †
For use in Japan only. Do not change the factory setting.
FT5535/4527/4522
Function
Resets all the correction data for process
control and all software counters, and returns
all modes and adjustments to the default
settings.
See Service Tables - section 2.2.4 for how to
perform this SP mode.
Normally, this SP mode should not be
performed.
This SP mode is required only when replacing
the RAM board, or when the copier
malfunctions due to a damaged RAM board.
SP5-802-001: Continuous free run
SP5-802-002: One time free run
Before starting, close the platen or ARDF.
Press the "Start" key to start the free run.
Press the "Clear/Stop" key to stop the free run.
Displays the data received from sensors and
switches.
Turns on the electrical components
individually for test purposes.
Resets any service call condition that was
caused by a level A error (see the
Troubleshooting section).
After doing SP5-810, turn the copier main
switch off and on.
Use this to input the telephone number of the
service representative (this is displayed when
a service call condition occurs.) Maximum 16
digits. Press the " " key to input a pause (–).
•
Press the "Clear/mode" key to delete the input
telephone number.
4-32
Settings
For details, see
Service Tables
section 2.5.
For details, see
Service Tables -
section 2.6.
FSM