15.7 MAIN CONTROL BOARD REPLACEMENT
1. Remove the rear cover (refer to Exterior Cover Removal), then
disconnect all connectors (15 connectors and 1 fiber optics connector).
2. Remove the main control board [A] (6 studs).
3. Install the new main control board and connect all connectors.
4. Position DIP SW 100, 101 and 102 as on the original main control board
(DIP SW 101 and 102 are for stapling position adjustment and DIP SW
100 is for SP mode).
5. Turn on the copier main switch then check the stapling position. If it is
incorrect, adjust the stapling position. (Refer to the Stapling Position
Adjustment.)
SM
REPLACEMENT AND ADJUSTMENT
3-39
[A]
A664R520.wmf
A207/A208/A211