Ricoh FT5535 Service Manual page 612

15.8 OIL SUPPLY ROLLER AND OIL SUPPLY ROLLER
CLEANING BRUSH REPLACEMENT
[D]
[G]
[B]
1. Remove the fusing unit. (See Fusing Unit Removal.)
2. Remove the fusing front cover and the fusing upper unit. (See Thermistor
And Thermofuse Replacement.)
3. Remove the upper fusing entrance guide [A] (3 screws).
4. Remove the grounding harness [B] (1 screw).
5. Remove the bracket [C] (2 screws).
6. Replace the oil supply roller [D] and the oil supply roller cleaning brush
[E] (2 screws and 2 bushings).
NOTE: 1) The screws [F] and [G] are very similar. When reinstalling, do not
mix them up. ([F] is longer than [G].)
2) The front oil supply roller bushing [H] is a one-way bushing.
When reinstalling, do not mix it up with the rear bushing.
SM
REPLACEMENT AND ADJUSTMENT
[H]
[F]
1-109
[C]
[E]
[G]
[A]
A204R507.wmf
A207/A208/A211