INSTALLATION
[A]
A204I514.wmf
28. Pull out the paper tray and load paper into it. (The paper size and
direction for each tray should be as specified by the customer.)
NOTE: The side and rear fences should be properly positioned.
29. Select the appropriate paper size for the paper trays in the main body by
sliding the paper size slider into the correct position (see Installation
section 2.3.2 in the base copier manual, "Paper size selection for the
copier paper trays" for details).
30. When a paper tray unit is installed: Enter the proper paper size for
each paper tray by following the procedure shown in Installation section
2.3 in the base copier manual, "Paper Size Selection" and in "Service
Tables - SP5-019: Paper Size Setting".
31. Load paper into the paper trays and the copy tray.
32. Attach the appropriate paper size decals [A] to the paper trays.
Also (A207/A211 copiers only), attach the duplex decal to the duplex tray.
NOTE: Paper size decals are used also for the paper tray unit. Save the
remaining decals for use with the paper tray unit.
33. Attach the cushion [B] at the center of the LCT upper stay [C] as shown.
NOTE: Make sure that the edge of the cushion is aligned with the line
where the stay is bent at a slight angle.
A207/A208/A211
A204I517.wmf
1-46
[B]
[C]
A204I518.img
SM