Rev. 1/26/96
Mode No.
•
°5-110
Center Erase
Margin
Adjustment †
°5-113
Coin Lock
Installation †
5-115
Duplex Image
Shift †
(Back Side
Margin)
°5-121
T/C (Total
Counter) Count
Up Timing †
•
°5-305
Auto Off Time
⇒
Setting †
°5-401
User Code
Mode †
•
°5-402
User Code
Counter Check
†
FT5535/4527/4522
Function
Adjusts the center erase margin width in erase
center mode.
SP5-908 must be at 1 for this to have any
effect.
(A4 version: 1 mm per step [Range: 8 mm
to 25 mm],
LT version: 0.01" per step [Range: 0.32" ~
1.00"])
Specifies whether coin lock is installed or not
(only for Japanese versions).
Specifies whether duplex image shift (back
side margin) is used or not.
If "YES" is selected, a 5 mm margin is made
on the right of the reverse side of copies when
making two-sided copies from one-sided
originals.
If the image shift mode has been selected with
SP5-908 and if the user uses image shift
mode, this SP mode has no effect.
Determines whether the total counter counts
up at paper feed or at paper exit.
Sets the time to go into the auto off condition. 1 ~ 120 minutes
After JP2 on the main board is cut, either key
counter mode or user code mode can be
selected with this SP mode.
Displays the user code counters.
The current user code is displayed in copy
counter, and the copy count for that user code
is displayed in the reduce/enlarge indicator.
•
Hold down the "
" key to display the last three
digits.
Use the
and
user code counter.
4-30
A4 version
LT version
0: Not installed
1: Installed
0: NO
1: YES
0: Feed
1: Exit
(1minute per step)
(Default: 60
minutes)
0: Key Counter
1: User Code
keys to check each
Settings
8 ~ 25
Default = 20
0.32 ~ 1.00
Default = 0.80
FSM