Removing The Master Stocker Roller ( Bottom) - Riso RZ3xx Series Technical Manual

19. Removing the Master Stocker Roller ( bottom)

(1) Pull out the master making unit and switch off the machine power.
(2) Remove the following components.
- Write pulse motor assembly
- Load pulse motor assembly
- Cutter cover assembly
- Master loading guide
- Clamping guide roller
- Cutter guide assembly
- master stocker roller pulley
(3) Remove the master making unit from the machine.
(4) Detach the master stocker spring from the master stocker lever.
(5) Detach the master stocker solenoid assembly by disconnecting the solenoid connector and removing
screws (M3x6: 2pcs).
- continues on next page -
Master stocker lever
Connector
RISO Inc. Technical Communications
CHAPTER 14: MASTER MAKING SECTION
< Rear of the master making unit >
Master stocker spring
< Master stocker solenoid assembly >
1479
[ 14 - 35 ]
1478
1480
us.riso.com