12. Removing the Cutter Cover Assembly (A3/Ledger machines only)
(1) Pull out the master making unit and switch off the machine power.
(2) Open the master making unit upper cover and remove following items.
-
Master roll
-
master making cover front
-
Write pulse motor assembly
-
Load pulse motor assembly
(3) Unplug the sensor connector, remove screws (M3x6: 2pcs), and detach the cutter cover assembly while
pulling out the wire harness from the hole on the machine side frame.
< Cutter cover assembly >
Master making unit upper cover set sensor
RISO Inc. Technical Communications
CHAPTER 14: MASTER MAKING SECTION
Master positioning sensor
< Cutter cover assembly >
( Under view )
[ 14 - 25 ]
1448
Cutter cover assembly
1449
1450
us.riso.com