Riso RZ3xx Series Technical Manual page 295

Jam errors
Error Type A01 [Master feed error]
A01-xxx
Description Master Mis-Feed
Pull Out Master Making Unit and Rewind Master Roll, then Reset Master in Place.
To reset Open the master-making unit and rewind the master material on the master roll, and then
display reset the master, or turn OFF the power and power back ON.
Error Point
Master-positioning sensor does not go ON even after the write pulse motor is activated during
201
the master-positioning, master-cut, or master-loading operation.
Master-positioning sensor does not go OFF even when the write pulse motor is reversed
202
during the master-positioning or at start of master-making operation.
211 Master-positioning sensor is ON during standby.
214 Master-positioning sensor is ON at the start of master making.
Faulty gate-array control for the write pulse motor (motor does not stop at programmed
215
timing).
Error Type A02 [Master loading error]
A02-xxx
Description Master Loading Error
Pull Out Print Cylinder and Discard Master.
To reset
Pull out the print cylinder and set it back.
display
Error Point
Master-loading sensor was OFF when the master was checked at a specified drum angle
509
during the master-loading operation.
Error Type A04 [Master removal error]
A04-xxx
Description Master Disposal Error
Pull Out Print Cylinder and Discard Master.
To reset
Pull out the print cylinder and set it back.
display
Error Point
303 Master-disposal jam sensor was OFF at both 120 and 180 degrees drum angle.
RISO Inc. Technical Communications
Error Conditions
Error Conditions
Error Conditions
[ 16 - 17 ]
CHAPTER 16: PANEL MESSAGE
us.riso.com