Removing The Master Making Unit - Riso RZ3xx Series Technical Manual

CHAPTER 14: MASTER MAKING SECTION

18. Removing the Master Making Unit

(1) Pull out the master making unit and switch off the machine power.
(2) Detach the master making cover front by removing screws (M4x8: 4pcs).
(3) Unplug the master flat cable from the master making PCB.
(4) Remove a screw (M3x8: 1pc) and detach the flat cable bracket. Then unhook the flat cable support plate
from the master making unit side frame (front) and let it hang down.
- continues on next page -
Master making unit side frame (front)
RISO Inc. Technical Communications
Flat cable bracket
Flat cable support plate
1468
[ 14 - 32 ]
1466
Master making PCB
Master making unit flat cable
1467
us.riso.com