Riso RZ3xx Series Technical Manual page 299

Option errors
Error Type B01 [Keycard counter: No card]
B01-xxx
Description
Insert Card in Key/Card Counter
To reset
Insert card.
display
Error Point
730 Keycard counter: No card
Error Type B22 [Job separator: Power off]
B22-xxx
Description !! Job Separator is OFF !!
Turn On Power Switch of it
To reset
Press Reset Key and check and switch ON the power of Job Separator.
display
Error Point
With the "Tape separation" function set ON, no power is supplied to the job separator when
721
start key is pressed.
After cluster-A signal turned ON, BUSY-signal stayed "L" more than 7 seconds (power to job
727
separator was turned OFF while the tape is being ejected.
Error Type B23 [Job separator: No tape]
B23-xxx
Description No Paper Tape in Job Separator
Replace Tape Roll
To reset
Press Reset Key and set paper tape in Job Separator.
display
Error Point
With the "Tape separation" function set ON, no tape detected in the job separator when the
722
start key is pressed.
723 No tape remains in job separator upon completion of the tape-ejection operation.
Error Type B24 [Job separator: Tape jam]
B24-xxx
Description Paper Tape Jam in Job Separator
Remove Paper Tape
To reset
Press Reset Key and remove the jammed tape.
display
Error Point
Tape jam detected when the start key is pressed with the "Tape separation" function set to
724
ON.
The tape-jam detection signal is "H" for more than 1.2 seconds after cluster-A signal turns ON
725
(tape misfeed).
Job separator tape-jam detection signal is "L" when the BUSY signal changes from "L" to "H"
726
(or after 7 sec. at "L") after the cluster-A signal goes ON (tape misfeed).
RISO Inc. Technical Communications
Error Conditions
Error Conditions
Error Conditions
Error Conditions
[ 16 - 21 ]
CHAPTER 16: PANEL MESSAGE
us.riso.com