Adjustment
1. G-lever Mounting Position Adjustment
Checks and adjustment
(1) Run Test mode No.889 (G-Lever mounting position) and then switch off the machine power.
(2) Remove the rear cover.
(3) Loosen the two screws on the G-lever assembly, joining the G-lever and release base in one piece.
(4) Push the G-lever cam follower against the timing cam and retighten the two springs, making sure that the
cam follower is touching the cam.
Release base
RISO Inc. Technical Communications
CHAPTER 5: SECOND PAPER FEED SECTION
G-lever
G-lever cam follower
0526
[ 5 - 17 ]
Timing cam
G-lever
0525
0527
us.riso.com