Removing The Suction Unit - Riso RZ3xx Series Technical Manual

CHAPTER 7: PAPER EJECTION SECTION

2. Removing the Suction Unit

(1) Switch off the machine power and detach the paper receiving tray.
(2) Remove the paper ejection cover by removing screws (M4x8: 4pcs).
(3) Remove the wing cam assembly. (Only on RZ3 series)
(4) Disconnect one wire harness connector, remove screws (M4x8: 2pcs) and pull the suction unit out while
lifting it up a little.
Paper ejection cover
RISO Inc. Technical Communications
Wing cam assembly
Suction unit
[ 7 - 6 ]
0709
0710
Connector
us.riso.com