Removing The Clamping Guide Roller - Riso RZ3xx Series Technical Manual

14. Removing the Clamping Guide Roller

(1) Pull out the master making unit and switch off the machine power.
(2) Open the master making unit upper cover and remove the master making cover front.
(3) Detach the master loading guide by removing screws (M3x6: 2pcs).
(4) Detach the spur gear by removing screws (M3x8: 1pc).
(5) Detach the snap ring from the rear side, unhook the metal bushing from the rear side frame and slide it
inward. Slide the clamping guide roller towards the rear and unhook the metal bushing from the front side
frame. Remove the clamping guide roller from the machine.
Master loading guide
Snap ring
Metal bushing behind the snap ring
RISO Inc. Technical Communications
Clamping guide roller
1454
< Rear >
[ 14 - 27 ]
CHAPTER 14: MASTER MAKING SECTION
1452
Clamping guide roller
< Front >
1453
Spur gear
1455
Metal bushing
us.riso.com