Riso RZ3xx Series Technical Manual page 320

CHAPTER 17: TEST MODE
No. Data setting
FB Horizontal Scan Position Adjust [For RZ2 series]
Description
0380
Setting
FB Horizontal Scan Position Adjust [For RZ3 series]
Description
0380
Setting
FB Scan Start Position Adjust
Description
0381
Setting
FB Scanning Speed Adjustment
Description
0382
Setting
Activates or deactivates center black dot setting
Description
0386
Setting
RISO Inc. Technical Communications
Adjusts the original horizontal scan position on the flatbed (For FB scanning).
Range : ±1.5mm from the programmed default position
(+ is to left )
0 to ±15 (example: 15 = 1.5mm)
Unit : 5 (0.5mm)
Default : 0 (0mm)
Adjusts the original horizontal scan position on the flatbed (For FB scanning).
Range : 0mm to ± 3.0mm from the programmed default position
(+ is to left )
0 to ±30 (example: 25 = 2.5mm)
Unit : 5 (0.5mm)
Default : 0 (0mm)
Adjusts the original scanning start position on the flatbed
Range : ±6.0mm from the programmed default position
(+ moves scan start position down)
0 to ±60 (example: 28 = 2.8mm)
Unit : 1 (0.1mm)
Default: 0 (0mm)
Adjusts the original scanning speed on the flatbed (Adjust the speed for Lead PM)
Range : ±5.0% from the programmed default position
( - causes shrinkage)
0 to ±50 (example: 50 = 5.0%)
Unit : 1 (0.1%)
Default : 0 (0%)
Creates the image which adds the center black dot to image data.
Range
0: No center black dot <Default>
1: Center black dot present
[ 17 - 8 ]
Details
us.riso.com