Riso RZ3xx Series Technical Manual page 290

CHAPTER 16: PANEL MESSAGE
Error Type P25 [No battery error]
P25-xxx
Description !!Low Battery!!
Call Service
To reset
Replace the battery.
display
Error Point
Battery voltage is too low when the power is turned ON.
026
(Readjust the machine clock after replacing the battery.)
Error Type P89 [Master compression plate: incorrect position]
P89-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Turn the power OFF and ON.
display
Error Point
The clamp unit is in the clamp-plate open position and also the master compression plate is
350 not in the HP position when the print drum starts its movement. (This is to protect the
machine parts.)
Error Type P92 [Drum EEPROM write error]
P92-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Press Reset Key
display
Error Point
EEPROM on the print drum PCB is being accessed while the print drum is in releasing action
570
from the machine.
Error Type P93 [NET-C hardware error]
P93-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Turn the power OFF and ON.
display
Error Point
932 No reply from the NET-C network interface card while accessing to the network interface card.
933 No response from NET-C for 90 seconds during NET-C initialization.
RISO Inc. Technical Communications
Error Conditions
Error Conditions
Error Conditions
Error Conditions
[ 16 - 12 ]
us.riso.com