Removing The Master Guide Gate (Excluding A3/Ledger Machine) - Riso RZ3xx Series Technical Manual

CHAPTER 14: MASTER MAKING SECTION

9. Removing the Master Guide Gate (excluding A3/Ledger machine)

(1) Pull out the master making unit and switch off the machine power.
(2) Open the master making unit upper cover and remove the master roll.
(3) Detach the two snap rings from the shaft of the write roller.
(4) Slide the two metal bushings inward on the write roller shaft and detach the master guide gate from the
shaft of the write roller.
Metal bushing
RISO Inc. Technical Communications
Master guide plate
Snap ring Write roller
Write roller
Master guide gate
1483
Write roller
[ 14 - 22 ]
1443
Snap ring Metal bushing
1444
us.riso.com