Removing The Drum Body - Riso RZ3xx Series Technical Manual

4. Removing the Drum Body

(1) Make a confidential master on the print drum and pull out the drum from the machine.
(2) Remove the following components.
- Screen assembly
- Master clamp base assembly
(3) Loosen screws (M3x6: 2pcs) on the potbelly-shaped hole towards the tail end of the drum body (indicated
by the arrow marks on the photograph), and remove all other remaining screws (M3x6: 10pcs).
(4) Holding the drum body, so it does not pop open, peel off the tape which holds the top edge of the drum
body onto the tail end of the drum body. (The tape will be reused in assembly.)
(5) Slide the drum body and unhook the potbelly-shaped holes from the two loosened screws, and then
remove the drum body.
- Precautions in assembly continues on next page -
RISO Inc. Technical Communications
< Enlarged View >
[ 8 - 11 ]
CHAPTER 8: PRINT DRUM SECTION
Drum body
Tape
0822
Joint section of the drum body.
0823
us.riso.com