P97 Pc Card Access Error; P98 Hardware Error - Riso RZ3xx Series Technical Manual

CHAPTER 16: PANEL MESSAGE
Error Type P97
P97-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Press Reset Key
display
Error Point
939 PC card access error: PC card not set.
940 PC card access error: PCMCIA card information error.
941 PC card access error: CF card device error.
942 PC card access error: Same file already exists.
943 PC card access error: Not formatted.
944 PC card access error: Media ID error.
945 PC card access error: Media error (cannot access the PC card).
946 PC card access error: Media error (not enough blank space available on CF card).
990 PC card access error: Specified file not found on the selected drive.
991 PC card access error: Accessed to the file not opened.
992 PC card access error: File information folder is already in use.
PC card access error: Incorrect setting on the readout address when sending data to the
993
machine.
994 PC card access error: Unsuccessful file deleting.
Error Type P98 [Hardware error]
P98-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Turn power OFF and ON.
display
Error Point
No reply from SH3M PCB. If SH3M PCB signal is detected at machine power ON, but if the
002 PCB communication terminates and P98-069 error is detected, the error point is rewrote to
002.
005 Hardware error
006 FRAM check-sum error
025 Defective RF PCB (Unsuccessful initial communication with RF PCB).
034 Unable to write on EEPROM on the machine. (Cannot access EEPROM).
035 CRC error on EEPROM on the machine (Defective EEPROM data).
038 Information between the PCB and EEPROM does not match.
039 Incorrect EEPROM.
053 Unsuccessful data readout from the Memory setting (program, mode, user paper).
054 Unsuccessful data writing of the Memory setting (program, mode, user paper).
RISO Inc. Technical Communications
[PC card access error]
Error Conditions
Error Conditions
[ 16 - 14 ]
us.riso.com