Removing The Af Original Detection Sensor, Af Read Sensor And Af Original Ejection Sensor - Riso RZ3xx Series Technical Manual

4. Removing the AF Original Detection Sensor, AF Read Sensor and AF Original Ejection Sensor

(1) Switch off the machine power and open the AF unit.
(2) Remove the AF cover and close the AF unit.
Removing the Original Detection Sensor
(3) Disconnect the connector and release the actuator, and remove the AF Original detection sensor.
Removing the AF Read Sensor
(3) Disconnect the connector to the sensor, remove a screw (M3x10: 1pc) and remove the AF read sensor.
* Following the reassembly, rotate the variable resistor VR1 on top of the AF-PCB to adjust LED 1 to the
maximum brightness.
Removing the AF Original Ejection Sensor
(3) Disconnect the connector to the sensor, release the actuator and remove the AF Original ejection sensor.
AF-PCB
RISO Inc. Technical Communications
AF Original detection sensor
AF Read sensor
[ 13 - 9 ]
CHAPTER 13: AF SCANNING SECTION
AF Original ejection sensor
1309
us.riso.com