Removing The Antenna Pcb - Riso RZ3xx Series Technical Manual

CHAPTER 14: MASTER MAKING SECTION

7. Removing the Antenna PCB

(1) Pull out the master making unit and switch off the machine power.
(2) Detach the master making cover front by removing screws (M4x8: 4pcs).
(3) Detach the master making PCB by removing screws (M3x6: 2pcs).
(4) Gently pull out the antenna connector, and detach the antenna PCB from the master holder (front) by
unhooking from the three plastic claws of the master holder.
RISO Inc. Technical Communications
[ 14 - 20 ]
Master making PCB
1439
Master holder (front)
Antenna PCB
1440
us.riso.com