10. Removing The Master Loading Roller Ass'y - Riso V8000 Series Technical Manual

CHAPTER 14. MASTER MAKING SECTION

10. Removing the Master Loading Roller Ass'y

(1) Remove the master making unit.
(2) Detach the E-ring and remove intermediate gear.
(3) Disconnect the master positioning sensor connector, remove the two mounting screws (M3 x 6) on
either side, and remove the master loading roller ass'y.
< REAR >
Connector of master positioning sensor
P1436
Master Making Unit
< REAR VIEW >
[14 - 16]
P1437
< FRONT >