Riso RZ3xx Series Technical Manual page 298

CHAPTER 16: PANEL MESSAGE
Error Type A16 [Waiting for the master to be removed from the drum]
A16-xxx
Description Master Remains on Print Cylinder (Drum)
Pull Out Print Cylinder and Remove Master
To reset
Pull out the print cylinder (drum), remove the master around it and insert it back.
display
Error Point
525 Waiting for the master to be removed from the print cylinder (drum).
Error Type A17 [Cutter error]
A17-xxx
Description System Error in Master Making Unit
Take Out Master and then Close Master Making Unit Cover
To reset
Open the Master making unit, remove the master and close the master making unit.
display
Error Point
Cutter HP switch is OFF when master-making starts or when the master material is set in the
209
master making unit.
Error Type A34 [Requesting for the master to be reset]
A34-xxx
Description Master Not Set in Place
Insert Lead Edge of Master into Master Entrance and Close Master Making Unit
To reset
Open the Master making unit, re-insert the master material into the master making unit.
display
Error Point
218 Reqesting for the master material to be reset into the master making unit.
RISO Inc. Technical Communications
Error Conditions
Error Conditions
Error Conditions
[ 16 - 20 ]
us.riso.com