Riso RZ3xx Series Technical Manual page 305

Error Type D17 [Incorrect master roll]
D17-xxx
Description Wrong-type Master Installed or Cannot Read Master Info
Replace Master Roll or Contact dealer/Riso office
To reset
Set correct master roll in the machine.
display
Error Point
236 Incorrect master roll.
237 Master roll RF-Tag not detected.
238 Master roll RF-Tag communication error. (Communication interrupted by noise)
239 Incorrect information on the Master roll RF-Tag.
241 Mismatch in the Master roll RF-Tag information.
256 Master roll RF-Tag software error.
Error Type D18 [Print cylinder (drum) is ready for removal]
D18-xxx
Description
Print Cylinder (Drum) has been Unlocked
To reset
Pull out the print Cylinder (Drum).
display
Error Point
522 Print Cylinder (Drum) is unlocked for its removal. (Drum lock Solenoid is ON).
Error Type D19 [Master making unit is ready for removal]
D19-xxx
Description
Master Making Unit has been Unlocked
To reset
Pull out the master making unit.
display
Error Point
223 Master making unit is unlocked for its removal. (Lock Solenoid is ON).
Error Type D22 [Print cylinder (drum) removal command]
D22-xxx
Print Cylinder (Drum) Not Set in Place.
Description
Press Cylinder (Drum) Release Button and Pull Out Print Cylinder (Drum)
after the Button Lights.
To reset
Pull out print cylinder (drum) from the machine.
display
Error Point
540 Cannot access to the EEPROM on the print drum PCB.
542 Print drum PCB EEPROM data error. (CRC error within the EEPROM.)
RISO Inc. Technical Communications
Error Conditions
Error Conditions
Error Conditions
Error Conditions
[ 16 - 27 ]
CHAPTER 16: PANEL MESSAGE
us.riso.com