Removing The Print-Positioning Intermediate Gear - Riso RZ3xx Series Technical Manual

5. Removing the Print-positioning Intermediate Gear

(1) Switch off the machine power and remove the rear cover.
(2) Remove the E-ring and detach the print-positioning intermediate gear.
<< Precaution on Reassembly >>
Mount the print-positioning intermediate gear back on the machine after inserting the 8mm diameter Jig shaft
into the position-B phase alignment hole on the paper feed area so all other gears are aligned in position-B.
RISO Inc. Technical Communications
Print positioning intermediate gear
CHAPTER 5: SECOND PAPER FEED SECTION
[ 5 - 11 ]
0517
us.riso.com