Riso RZ3xx Series Technical Manual page 284

CHAPTER 16: PANEL MESSAGE
Error Type P03 [Clamp motor lock]
P03-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset
Press Reset Key
display
Error Point
Clamp sensor A is OFF after the completion of the clamp unit initialization or home positioning
500
movement.
Clamp sensor B does not change within 1 second from the time the clamp motor operates in
501
the forward direction.
Clamp sensor B does not change within 1 second from the time the clamp motor operates in
502
the reverse direction.
Clamp sensor A does not go ON within 3 seconds when the clamp unit makes initialization
503
movement.
At the start of Clamp plate open/close action, the detection sequence of clamp-sensors A &
504
B are abnormal.
At the start of print drum Position-A compensation movement, the detection sequence of
505
clamp-sensors A & B are abnormal.
At the start of Clamp unit Home-positioning movement, the detection sequence of clamp-
506
sensors A & B are abnormal.
507 Clamp sensor A is ON after the clamp release action is completed.
508 Clamp sensor A is ON after the A-position compensating movement is completed.
Clamp unit is not in the home position while the print drum is in movement (cause due to the
545
clamp motor).
Error Type P04 [Ink overflow]
P04-xxx
!!System Error!!
Description
Press Reset Key
If Recovery has Failed, Call Service
To reset Press Reset Key after correcting the ink overflow condition. (No ink on the ink overflow
display sensor.)
Error Point
The overflow sensor is ON for a set number of times in succession during the 10-millisecond-
513
interval overflow-sensor check.
RISO Inc. Technical Communications
Error Conditions
Error Conditions
[ 16 - 6 ]
us.riso.com