Removing The Transfer Belts (Rz3 Series) - Riso RZ3xx Series Technical Manual

6-1. Removing the Transfer Belts (RZ3 series)

(1) Switch off the machine power and remove the following components.
- Paper receiving tray
- Paper ejection cover
- Suction unit
(2) Remove the suction upper assembly.
(3) Detach the suction box by removing screws (M3x8: 4pcs).
(4) Detach the joint plate-M and joint plate-S by removing screws (M3x8: 2pcs each)
(5) Lift the shaft-2 assembly with a finger, unhook it from the suction upper assembly and detach it.
(6) Remove the transfer belts by first dropping them in the gap between the wing-S and transfer base to ease
the tension of the belts.
Joint plate-M
Suction box
Transfer base
Shaft-2 assembly
Wing-S
Transfer base
RISO Inc. Technical Communications
CHAPTER 7: PAPER EJECTION SECTION
0724
Transfer belts
[ 7 - 11 ]
Joint plate-S
0723
0725
0726
us.riso.com