Removing The Memory Card - Riso MH Series User Manual

44
Chapter 2 Basic Operations
1
Turn off the power to this machine.
Press the [Y] side of the power switch.
2
Remove the cover for the card
slot.
Turn the thumbscrew by hand counterclock-
wise to loosen it.
Slide the cover to the left, and then remove the
cover.
BDo not loosen or remove any
screws other than the screw that
is specified in the figure.
3
Insert a new card into the slot.
Set the card in the direction that is shown in the
figure and insert it until you hear a click sound.
BBe sure to insert the card into the
correct direction. If the card is
inserted in the wrong direction,
the card may be damaged.
BBefore inserting the card, remove
its write protection.
If there is a switch with a label
such as "LOCK" on the side or
back of the card, slide the switch
to remove write protection.
Thumbscrew
4
Attach the cover.
Return the cover to its original position, and
then turn the thumbscrew clockwise to tighten
it.

Removing the memory card

1
Push in the card until you hear a
click sound.
2
Slowly release your finger.
The card is ejected.
With your fingers, pinch and pull out the card.