3. RF-Tag Antenna PCB
1) Remove the Drum from the machine, turn OFF the machine power and remove the Front cover
from the machine. (M3x8 screws; 6 pcs)
2) Unplug the wire harness connector of the RF-Tag Antenna.
3) Open the Master making upper unit.
4) Remove the Master holder unit (front). (M3x8 screws; 2 pcs)
5) Remove the RF-Tag Antenna PCB from the Master holder unit (front) by carefully releasing the
hooks.
CZ180 / CV1860 Rev. 1.0
RISO Inc. Technical Services & Support
CHAPTER 12: MASTER MAKING SECTION
Master holder assembly (front)
Unit main frame
Master holder assembly (front)
Antenna assembly
RF-PCB
Master holder (front)
12 - 7
US.RISO.COM