Hp Sensor Assembly Removal - Epson Stylus Photo Service Manual

3.2.5.9 HP Sensor Assembly Removal

1. Removing the upper housing. (Refer to section 3.2.1)
2. Detach the cable from the sensor and remove it by unhook it from the frame.


Make sure that the sensor itself is attached firmly to the frame when installing the HP sensor
again.


Be careful not to damage the sensor board when installing or pulling out the cable from the HP
sensor.
Rev. A
Figure 3-25. HP Sensor Removal
CAUTION
Chapter 3 Disassembly and Assembly
3-27