3.8 Home Position (HP) Sensor Removal
1. Remove the upper housing. (See Section 3.4.)
2. Using tweezers, release 2 hooks fixing the HP sensor to the sub pump frame. Then remove
the HP sensor by pulling it downward. (See Figure 3-15.)
3. Disconnect the HP sensor connector cable from the HP sensor.
Note the direction in which the HP sensor is attached. Place the cable side down.
Tightening torque for the screws (CBS, 3x8, F/Zn) = 8 ~ 10 kg-cm.
Rev. A
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Figure 3-15. HP Sensor Removal
Disassembly and Assembly
3-15
Need help?
Do you have a question about the Stylus COLOR 800 and is the answer not in the manual?