Restore Factory Margins Settings; Resetting Connection Setup Defaults; Resetting Paper Handling Defaults (6300/6350 Only) - Xerox Phaser 6360 Service Manual

Restore Factory Margins Settings

Resetting Connection Setup Defaults

Resetting Paper Handling Defaults (6300/6350 Only)

Phaser 6300/6350/6360 Color Laser Printer Service Manual
You can reset margin settings to the factory-default values.
Caution
Use caution when resetting your margins to the factory-default settings.
Changing these settings back to factory defaults may not be the last-
saved settings if you have previously calibrated your margins.
1. On the Control Panel, select Troubleshooting, and then press the OK
button.
2. Select Print Quality Problems
3. Select Calibrate Margins
4. Select Restore Factory
the margin settings.
Resetting the Connection Setup values sets TCP/IP address, TCP/IP address
menu settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware,
set IPX frame type, IPP, Ethernet speed, Wait Timeout, Page Description
Language, and USB Port selection to their default values.
Caution
Make note of the current network settings or print a Configuration page to
provide a record of the customer's current network settings before
resetting the connection setup to the factory default values.
1. On the Control Panel, select
button.
2. Select Connection
3. Select Reset Connection
connection defaults.
Resetting the Paper Handling defaults resets the paper source, 2-sided
printing, tray setup, load paper timeout, tray sequence, custom units and jam
recovery settings to their default values.
1. On the Control Panel, select
button.
2. Select Paper Handling
3. Select Reset Paper Handling
4. Select Reset Paper Handling Setup
to reset the paper handling defaults.
menu, and then press the OK button.
menu, and then press the OK button.
Settings, and then press the OK button to reset
Printer Setup, and then press the OK
Setup, and then press the OK button.
Setup, and then press the OK button to reset
Paper Tray Setup, and then press the OK
Setup, and then press the OK button.
Setup, and then press the OK button.
NOW, and then press the OK button
Adjustments and Calibrations
6-5