Tray 2 Paper Is Low - Xerox Phaser 6360 Service Manual

Error Messages and Codes

Tray 2 Paper Is Low

3-46
Troubleshooting Reference Table
Applicable Parts
Pertinent toner cartridge,
■
PL7.2.8~11
Troubleshooting Procedure Table
Step Actions and Questions
1 Has the shipping ribbon been
completely removed from the Toner
Cartridge?
2 Open and close Door A.
Does the error persist?
Test the affected Toner Motor.
3
Run the Service Diagnostics Toner
Motor test for the affected color.
Verify the Auger rotates and the Auger
system is unobstructed.
Does the error persist?
The tray's Low Paper Sensor indicates a Low Paper condition.
Applicable Status Code:
Warning: Tray 2 is Low
Initial Actions:
■ Check that Tray 2 is at least half full of paper and free of obstructions.
■ Insert the tray and cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Low Paper Sensor, PL3.3.7
■
Low Paper Sensor Actuator,
■
PL3.3.14
FDR Harness, PL3.3.22
■
Wiring and Plug/Jack References
Yes
Go to Step 2.
Go to Step 3.
Refer to "Install
or Lock [Y] [M]
[C] [K] Toner
Cartridge" on
(page 3-41).
Wiring and Plug/Jack References
Print Engine Map 4 - P/J Locator (page 10-8)
■
Print Engine Tray 2 Wiring (page 10-18)
■
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
Remove the
ribbon and cycle
printer power.
Complete
Complete