Electrical - Xerox Phaser 6360 Service Manual

Electrical

Phaser 6300/6350/6360 Color Laser Printer Service Manual
Note
Many of the electrical components used in the 6360 model differ from
those used in 6300/6350 models. The LVPS Fan is only used in 6360
models. Use care when selecting the replacement parent assembly or
component part
Image Processor Board
High Voltage
Power Supply Board
I/P Board
NVRAM
Engine Control Board
■
Image Processor Board
Receives data from the workstation or host, rasterizes the data and
passes it on to the Engine Control Board. The microprocessors on the
Image Processor Board, generate the control signals used by the Engine
Control Board. Also located on the Image Processor Board are the
system NVRAM chip, Memory, and optional Hard Drive.
■
EEPROM Board
Consumable use (Fuser and Imaging Unit NVRAM data) information is
stored and communicated to the Engine Control Board.
■
Rear and LVPS Fans
Remove heat from the printer to prevent over-heating.
■
Power Switch
An actuator and linkage is used to activate the Power Switch located on
the Low-Voltage Power Supply.
■
High-Voltage Power Supply Board (HVPS)
Supplies high-voltage to the Transfer Roller and Imaging Unit.
LVPS Fan
Hard Drive
Power Switch Actuator
Engine Control Board
NVRAM
Theory of Operation
Rear Fan
EEPROM Board
Memory
Low Voltage
Power Supply
AC Switch Harness
Power Switch
Power Switch Link
s6360-065
2-45