Option Feeder Harness (Pl3.2.11) - Xerox Phaser 6360 Service Manual

Option Feeder Harness (PL3.2.11)

Phaser 6300/6350/6360 Color Laser Printer Service Manual
The option connector located at the end of the Option Feeder Harness may
be disconnected from the replacement harness and used to repair a damaged
connector. The connector's construction allows for replacement without
removal of the printer chassis. Remove the Right Cover, Disconnect P/J17 at
the Engine Control Board to provide slack in the harness, then move the
printer so the connector overhangs the edge of the supporting surface and
squeeze the hooks to release the damaged connector from the frame.
When replacing the entire harness, follow this procedure:
1. Remove the Printer Chassis (page 8-24).
2. Remove the Option Feeder harness from the harness guide of the Right
Feeder.
3. Release the 2 hooks that secure the Option Feeder harness connector to
the Right Feeder.
4. Remove the Option Feeder harness from the bottom of the Right Feeder.
Service Parts Disassembly
s6360-144
8-29