Messages, Codes, And Procedures; Error Message Abbreviations - Xerox Phaser 6360 Service Manual

Messages, Codes, and Procedures

Error Message Abbreviations

Phaser 6300/6350/6360 Color Laser Printer Service Manual
The error messages and codes generated by the printer's operating system
are the lead-in to the troubleshooting procedures that follow in subsequent
pages. This section correlates the output of the printer's diagnostic aids and
provides the troubleshooting procedure to locate and correct reported errors.
Due to limited display space, some error messages include abbreviations.
The most common abbreviations used throughout this chapter are listed here.
Term Definition
Reg or Registration
REGI
SNR Sensor
DUP Duplex
I/P Board Image Processor
LTA Lower Tray Assembly
HCF High-Capacity Feeder
MSI or Multi-Sheet Input
MPT
P/J Plug/Jack
SW Switch
NVM Non-volatile Memory
CRUM Customer-Replaceable
Unit Monitor
Comm Communication
TNR Toner
FDR Feeder
FSR Fuser
CTD/ADC Toner Density Control
LVPS Low-Voltage Power
Supply
PWB Printed Wire Board
HVPS High-Voltage Power
Supply
Error Messages and Codes
Comment
Used in designators such as Reg SNR
Often seen as SNR1 or Reg SNR
Optional for 2-sided printing
Image Processor Board
Optional 550-Sheet Feeder (Tray 3)
Optional 1100-Sheet Feeder
Used to describe Tray 1 (MPT)
Plug (P) and or Jack (J) designators
Appears as a designator.
Used instead of NVRAM.
Device used to store usage information on
the Imaging Unit and Toner Cartridges.
As in Comm Error
Used as an abbreviation for Toner
Used as an abbreviation for Feeder
Used as an abbreviation for Fuser
Designator for the CTD/ADC Sensor
Primary power supply
Used to describe a circuit board
Supplies voltages to the Imaging and Laser
units
3-5