Fuser Fan Failure - Xerox Phaser 6360 Service Manual

Error Messages and Codes

Fuser Fan Failure

3-72
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
Check the Fuser for damage.
2
Is the Fuser connector damaged?
3 Replace the Fuser (page 8-7).
Does the error persist?
Check all pins on the FSR/ADC
4
Harness PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J361.
2. Check continuity between J36 <=>
J361.
The Fuser Fan rotation signal indicates to the Engine Control Board that the
fan is no longer operational.
Applicable Status Code:
Code 50: Fuser Fan Failure
Troubleshooting Reference Table
Applicable Parts
Fuser Fan, PL5.3.31
■
FAN/PHD/MOT Harness, PL10.1.9
■
Engine Control Board, PL9.1.16
■
Troubleshooting Procedure Table
Step Actions and Questions
Check the Fuser Fan for damage.
1
Remove the Front Cover.
Is the fan damaged?
2 Check the Fuser Fan connection.
Is P/J482 connected to the harness?
3 Check orientation of the Fuser Fan.
Does the Fan's label face into the
chute?
Test the Fuser Fan.
4
Run the Service Diagnostics Fuser Fan
test.
Does the Fan operate.
Yes
Repair or replace
the Fuser.
Go to Step 4.
Replace the
Engine Control
Board
(page 8-106).
Wiring and Plug/Jack References
Print Engine Map 1 - P/J Locator (page 10-5)
■
Print Engine Drive Wiring (page 10-19)
■
Yes
Replace the Fuser
Fan (page 8-67).
Go to Step 2.
Go to Step 3.
Go to Step 6.
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
Go to Step 3.
Complete
Replace the FSR/
ADC Harness.
No
Go to Step 2.
Reconnect the
Fan.
Correct the
installation.
Go to Step 5.