Xerox Phaser 6360 Service Manual page 131

Phaser 6300/6350/6360 Color Laser Printer Service Manual
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
Test the Feed Solenoid.
14
Run the Service Diagnostics Feed Solenoid
test.
Does the solenoid function correctly?
Check for +24 V to the Feed Solenoid.
15
1. Disconnect P/J824
2. Close the Interlock Switch while testing.
Is there +24 V across P824-2 <+>ground?
16 Check all pins on the OPFDR Harness
PL11.3.24 for continuity.
1. Disconnect P/J85 and P/J824.
2. Check continuity between J85 <=>
P824.
17 Test the Feed Solenoid resistance.
Disconnect P/J824.
Is J824-1 <=> J824-2 less than 100Ω?
Check all pins on the OPFPLG Harness
18
PL3.2.11 for continuity.
1. Disconnect P/J171 and P/J17.
2. Check continuity between P171 <=>
J17.
Error Messages and Codes
Yes No
Check the feed Go to Step 15.
solenoid
stopper and
replace if
necessary.
Go to Step 17. Go to Step 16.
Go to Step 17. Replace the
OPFDR
Harness.
Go to Step 17. Replace the
Feed Solenoid
(Part of the
Paper Pick
Assembly).
Replace the Replace the
Engine Control OPFPLG
Board Harness
(page 8-106). (page 8-29).
3-31