Consumable/Routine Maintenance Procedures; Install Or Reseat Imaging Unit - Xerox Phaser 6360 Service Manual

Consumable/Routine Maintenance Procedures

Install or Reseat Imaging Unit

Phaser 6300/6350/6360 Color Laser Printer Service Manual
The Imaging Unit CRUM fails to detect the Imaging Unit.
Applicable Status Code:
Code 212: Install or Reseat Imaging Unit
Initial Actions:
■
Remove and reseat the Imaging Unit.
■
Ensure that Door C is fully closed.
■ Cycle printer power.
■
If the problem persists, follow the procedure below
Troubleshooting Reference Table
Applicable Parts
Imaging Unit, PL6.1.1
■
CRUM Connector, PL7.1.4
■
PHD2 Harness, PL7.1.7
■
FAN/PHD/MOT Harness, PL10.1.9
■
Troubleshooting Procedure Table
Step Actions and Questions
Remove the Imaging Unit.
1
Inspect the printer cavity for damage,
debris, and toner under the auger area
preventing the Imaging Unit from
being seated properly.
Is there foreign material or damage?
Inspect and reseat the Imaging Unit.
2
Does the error persist?.
3 Check Imaging Unit CRUM connection.
Are P/J710 and P/J484 connected?
Check all pins on the PHD2 Harness
4
PL7.1.7 for continuity.
1. Disconnect P/J710 and P/J484.
2. Check continuity between
J484<=>J710.
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 2 - P/J Locator
■
(page 10-6)
Print Engine Laser Unit Wiring
■
(page 10-23)
Yes
Remove foreign
material.
Vacuum out loose
toner if found.
Go to Step 3.
Go to Step 4.
Go to Step 5
No
Go to Step 2.
Complete
Reconnect the
CRUM.
Replace PHD2
Harness.
3-33