Density Sensor Failure - Xerox Phaser 6360 Service Manual

Error Messages and Codes

Density Sensor Failure

3-68
An error was detected in the CTD (ADC) sensor.
Applicable Status Codes:
Code 13: Density Sensor Failure.
Code 14: Density Limit Over Output.
Code 15: Density Limit.
Code 16: This is the generic fault used by the engine if a lower level error
cannot be reported to the controller.
Troubleshooting Reference Table
Applicable Parts
Transfer Roller, PL5.1.4
■
FSR/ADC Harness, PL5.2.28
■
CTD(ADC) Sensor Holder, PL5.2.19
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault
or damage:
Transfer Roller, PL5.1.4
■
CTD (ADC) Sensor Holder, PL5.2.19
■
Are any parts damaged?
Clean the CTD (ADC) Sensor.
2
Does the error persist?
3 Test the CTD (ADC) Sensor.
Run the Service Diagnostics CTD (ADC)
Sensor test.
Does the sensor function correctly?
4 Replace the Transfer Roller.
Does the error persist?
Check all pins on the FSR/ADC Harness
5
PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J136.
2. Check continuity between J36 <=>
J136.
Check the CTD (ADC) Sensor signal.
6
Disconnect P/J136.
Is there 0 V across P136-4 <=> P136-
1?
Wiring and Plug/Jack References
Print Engine Map 2 - P/J Locator (page 10-6)
■
Print Engine Wiring Xerographics (1/2)
■
(page 10-24)
Yes
Replace any
damaged parts.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Replace the CTD
(ADC) Sensor
Holder
(page 8-72).
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
Go to Step 2.
Complete
Go to Step 5.
Complete
Replace the
FSR/ADC
Harness.
Replace the
Engine Control
Board
(page 8-106).