Configuration Errors; Invalid Or Missing Configuration Card - Xerox Phaser 6360 Service Manual

Configuration Errors

Invalid or Missing Configuration Card

Phaser 6300/6350/6360 Color Laser Printer Service Manual
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
3
Check the Paper Size Switch signals.
Verify +3.3 V on pins:
P/J821-1 <=> P/J80-4
P/J821-3 <=> P/J80-2
P/J821-4 <=> P/J80-1
Is there +3.3 V when actuated?
Check all pins on the SIZE Harness for
4
continuity.
1. Disconnect P/J80 and P/J821.
2. Check continuity between J80 <=>
J821.
Check all pins on the OPFREC Harness
5
continuity.
1. Disconnect P/J171 or P/J172 and P/
J83.
2. Check for continuity between J171/2
<=> P83.
The printer's Configuration Card is missing or defective.
Troubleshooting Reference Table
Applicable Parts
Configuration Card, PL9.1.31
■
Image Processor Board, PL9.1.3
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Configuration Card
installation.
Remove and reinsert the
Configuration Card.
Does the error still occur?
Error Messages and Codes
Yes
Go to Step 4.
Go to Step 5.
Replace the
Engine Control
Board
(page 8-106).
Wiring and Plug/Jack References
Yes
Replace the
Configuration
Card. If the
problem persists,
replace the I/P
Board (page 8-99).
No
Replace the
affected Paper
Size Switch
(page 8-28).
Replace the
Size Harness.
Replace the
affected
OPFREC
Harness.
No
Problem
solved.
3-65