Xerox Phaser 6360 Service Manual page 384

Hide thumbs Also See for Phaser 6360:

Table of Contents

Service Parts Disassembly

Disconnect P/J17, P/J22, P/J47, P/J52, and P/J60 from the Engine

Control Board.

Remove the screw (metal, 6 mm) that secures the Engine Control Board

Bracket to the right side of the printer.

Lift the right edge of the board slightly and pull the Engine Control Board

out from the printer while removing connections as they are exposed.

Replacement Note

When replacing the Engine Control Board, either replace the NVRAM

device on the new board with the one removed from the old board, or

restore the data saved in Step 1 by using the Restore utility included

in Service Diagnostics.

Also, reconnect P/J15, P/J16, and P/J34 before reinserting the board

into the printer. In addition, connectors P/J13 and P/J36 have an

equal number of Pins. These connectors are keyed differently but use

care to make certain that the proper connection is being made.

Use care re-routing the harnesses after replacing the board.

Phaser 6300/6350/6360 Color Laser Printer Service Manual

Show Quick Links

Table of Contents

Troubleshooting

Phaser 6300 Phaser 6350