Color Calibration; Margin Calibration - Xerox Phaser 6360 Service Manual

Adjustments and Calibrations
Calibrations

Color Calibration

Margin Calibration

6-2
Color calibration procedures adjust the printer for optimal color output. Color
settings may need adjustment:
■
On initial printer setup.
■ When Toner Cartridges and Imaging Units are replaced.
■
When the printer environment changes.
■
If the printer has been stored for some time.
■
If the printer has not received significant use.
There are two procedures; lighten/darken colors and balance colors.
If the overall image appears either too light or dark, use the lighten/darken
colors procedure. If a finer adjustment of the primary colors, cyan, magenta
and yellow, is needed, continue with the balance colors procedure.
Print the Color Calibration Colors Tutorial page from the printer's Control
Panel Troubleshooting
instructions detailed on the page.
The Calibrate Margins menu allows you to adjust the printer's imaging area
relative to the edges of the paper. The imaging area is shown as a dashed
rectangle on the front side of the print, the printer will not print outside this
rectangle. The dashed rectangle should line up with the solid rectangle
printed on the back side of the page. Hold up to strong light for verification.
Print the Calibrate Margins page for the appropriate tray from the
Troubleshooting --> Print Quality Problems
instructions detailed on the page.
--> Print Quality Problems
menu and follow the
Phaser 6300/6350/6360 Color Laser Printer Service Manual
menu and follow the