Remove Ribbon From [Y] [M] [C] [K] Toner Cartridge - Xerox Phaser 6360 Service Manual

Remove Ribbon from [Y] [M] [C] [K] Toner Cartridge

Phaser 6300/6350/6360 Color Laser Printer Service Manual
Troubleshooting Procedure Table
Step Actions and Questions
Check the following for evidence of fault
1
or damage:
Transfer Roller Assembly, PL5.1.4
■
CTD (ADC) Sensor, PL5.2.19
■
Check the CTD (ADC) Sensor
2
connection.
Is P/J136 connected to the harness?
Replace the CTD (ADC) Sensor
3
(page 8-72).
Does the error persist?
Check all pins on the FSR/ADC Harness
4
PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J136.
2. Check continuity between J36 <=>
J136.
Check the CTD (ADC) Sensor signal.
5
Disconnect P/J136.
Does P136-4 <=> P136-1 = 0 V?
The printer detected that one of the Toner Cartridge ribbons has not been
removed.
Applicable Status Codes:
Code 215: Remove Ribbon from Cyan Toner Cartridge
Code 216: Remove Ribbon from Magenta Toner Cartridge
Code 217: Remove Ribbon from Yellow Toner Cartridge
Code 218: Remove Ribbon from Black Toner Cartridge
Initial Actions:
■
Remove the Toner Cartridge and ensure that the ribbon tape has been
completely removed.
■
Inspect the mouth of the toner auger for obstructions or debris.
■ Test the affected Toner Motor.
■ Cycle printer power.
■
If the problem persists, follow the procedure below.
Error Messages and Codes
Yes No
Replace the Go to Step 2.
damaged parts.
Go to Step 3. Reconnect the
sensor.
Go to Step 4. Complete.
Go to Step 5. Replace the
FSR/ADC
Harness.
Replace the CTD Replace the
(ADC) Sensor Engine Control
(page 8-72). Board
(page 8-106).
3-45