Fuser Motor Failure - Xerox Phaser 6360 Service Manual

Error Messages and Codes

Fuser Motor Failure

3-82
The Fuser Motor rotation signal indicates that the motor is no longer
operational.
Applicable Status Code:
Code 103: Fuser Motor Failure
Initial Actions:
■
Ensure that the Fuser is fully seated and locked in position.
■ Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser Drive Assembly, PL5.2.25
■
TNRFULL/FSR Harness, PL5.2.30
■
Engine Control Board, PL9.1.16
■
Interlock Switch, PL9.1.1
■
Warning
Avoid the potential of electric shock by removing the power cord from the
wall outlet prior to performing the following procedure.
Caution
Allow adequate time for the Fuser to cool before servicing the printer.
Troubleshooting Procedure Table
Step Actions and Questions
Check the Fuser Drive Assembly for
1
damage.
Are any parts of the Fuser Drive
Assembly damaged or excessively
worn?
2 Check the Fuser Motor connection.
Is P/J521 connected to the harness?
Test the Fuser Motor.
3
1. Close the Interlock Switch while
testing.
2. Run the Service Diagnostics Fuser
Motor test.
Does the motor operate?
Wiring and Plug/Jack References
Print Engine Map 2 - P/J Locator (page 10-6)
■
Print Engine Wiring Fuser (page 10-22)
■
Yes
Replace the Fuser
Drive Assembly
(page 8-97).
Go to Step 3.
Go to Step 5.
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
Go to Step 2.
Reconnect the
Fuser Motor.
Go to Step 4.