Toner Cartridge Holder Assembly - Xerox Phaser 6360 Service Manual

Toner Cartridge Holder Assembly

Phaser 6300/6350/6360 Color Laser Printer Service Manual
Complete removal of the Toner Cartridge Holder Assembly is not required to
access the upper most Laser Unit screw. Use the following procedure to
loosen the assembly and lift it approximately 0.5 inch it to allow access to the
Laser Unit screw without disconnecting the Auger Tubes or removing the
Toner Cartridges.
Warning
Be sure to clean up any residual toner on the Toner Cartridge Holder
Assembly with a dedicated toner vacuum cleaner. Do not clean up toner
with a general-purpose vacuum cleaner to avoid the risk of explosion by
igniting the fine powder. As an additional precaution, be sure to attach a
ground cable to the toner vacuum cleaner to discharge static electricity.
Caution
Take care not to allow toner dust to adhere to the photo sensors located
on the Toner Cartridge Holder Assembly. Toner adhering to the photo
sensors reduces their efficiency and could cause erroneous errors.
1. Remove the Top Main Cover (page 8-11).
Note
To control toner spillage, after removing the Top Main Cover, replace the
Toner Cartridges and lock them into place.
2. Remove the Right Side Cover (page 8-14).
3. Remove the Left Side Cover (page 8-15).
4. Remove the Rear Cover (page 8-17).
5. Remove the 2 wires (red) from the harness guide on the CRUM Reader.
Service Parts Disassembly
8-91