General Troubleshooting
POST Soft Fault Messages
4-4
When POST detects a soft error, the printer continues the startup process.
Before the printer reaches its "Ready" state, the Startup page is printed with
soft errors appearing in a red box. The box contains all soft faults
encountered, with the upper left corner of the box in the center of the Startup
page, and extending to the right margin, similar to the one shown here.
These messages are substituted for <device>:
■
Ethernet
■
USB
■
Real-Time Clock
■
RAM Memory Slot 1 Checksum
■
RAM Memory Slot 2 Checksum
■
RAM Memory Slot 1 Rejected
■
RAM Memory Slot 2 Rejected
■
Max RAM Limit
■
IDE Disk
For Ethernet, USB, and Real-Time Clock errors, replace the Image Processor
Board. For IDE Disk errors, replace the Hard Drive. For memory errors, see
"RAM Memory Fault Isolation" on page 4-17.
Hardware Failure:
<device>:
General Failure
Phaser 6300/6350/6360 Service Manual