Replace Fuser - Xerox Phaser 6360 Service Manual

Replace Fuser

Phaser 6300/6350/6360 Color Laser Printer Service Manual
Troubleshooting Procedure Table
Step Actions and Questions
Cycle power to the printer.
1
Does the error persist?
2 Check the Fuser for damage.
Is the Fuser damaged?
Check Fuser resistance.
3
1. Remove the Fuser.
2. Disconnect J361.
3. Is the resistance between P361-B5
<=> P361-B4 less than 400KΩ?
4. Is the resistance between P361-B5
<=> P361-B4 less than 7MΩ?
4 Check all pins on the FSR/ADC Harness
PL5.2.28 for continuity.
1. Disconnect P/J36 and J361.
2. Check continuity between J36 <=>
J361.
The Fuser Life counter indicates that the Fuser has reached its end of life.
Fuser replacement is necessary to avoid print quality problems.
Note
There is no hard stop associated with the Replace Fuser message.
Applicable Status Code:
Code 207: Replace Fuser
Initial Actions:
■
Print the Supplies Usage page to verify remaining life and Fuser install
date.
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Error Messages and Codes
Yes No
Go to Step 2. Complete
Replace the Fuser, Go to Step 3.
then cycle power.
Go to Step 4. Replace the
Fuser
(page 8-68).
Replace the Replace the
Engine Control FSR/ADC
Board Harness.
(page 8-106).
3-39