Xerox Phaser 6360 Service Manual page 136

Error Messages and Codes
3-36
Troubleshooting Procedure Table
Step Actions and Questions
Check the following for evidence of
1
fault or damage:
Transfer Roller PL5.1.4
■
CTD (ADC) Sensor PL5.2.19
■
Is there any damage?
2 Clean the CTD (ADC) Sensor.
Does this fix the problem?
Test the CTD (ADC) Sensor.
3
Run the Service Diagnostics CTD
(ADC) Sensor test.
Does the sensor function correctly?
4 Replace the Transfer Roller.
Does the error persist?
Check the CTD (ADC) Sensor
5
connection.
Is P/J136 connected to the harness?
Check all pins on the FSR/ADC
6
Harness PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J136.
2. Check continuity between J36 <=>
J136.
Check the CTD (ADC) Sensor signal.
7
Disconnect P/J36.
Does J36-2 <=> J36-5 = 0 V?
Yes
Replace any
damaged parts.
Complete
Go to Step 4.
Go to Step 5.
Go to Step 6.
Go to Step 7.
Replace the CTD
(ADC) Sensor
(page 8-72).
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
Go to Step 2.
Go to Step 3.
Go to Step 5.
Complete
Connect the
sensor.
Replace the FSR/
ADC Harness.
Replace the
Engine Control
Board
(page 8-106).